Question types

Start with

Question limit

of 96 available terms

Print test

96 Multiple choice questions

  1. identifying areas that provide cover and/or concealment.
  2. As you pull the slide back for the last time, push the slide stop up with your shooting hand thumb until the slide locks to the rear in the open position.

    Keep the muzzle pointed in a safe direction at all times.

    Use your support hand thumb and index finger to grab the slide and pull it to the rear several times.

    With the slide locked back, tilt the weapon and physically and visually inspect to make sure the chamber and magazine well are empty.
  3. Shotgun
  4. cover
  5. destroy the primer and powder of loaded cartridges.
  6. Phase 1 Clearance does not clear the malfunction, or if the malfunction is a double feed.
  7. handgun/standing
  8. 1
  9. go to your secondary weapon (if available)
  10. you should go to a secondary weapon if a squib load occurs (in your revolver).
  11. 2
  12. tactical
  13. failure to feed
  14. Cover
  15. 1
  16. certified armorer can fix it.
  17. a squib load, failure to fire, failure to feed, failure to extract (double feed), or failure to eject (stovepipe).
  18. the rear and the fore-end and the receiver, this can cause an injury.
  19. failure to fire
  20. tactical consideration in using cover.
  21. transition to a secondary weapon or retreat if a squib load occurs to his or her semiautomatic rifle/carbine.
  22. concealment is not necessarily cover.
  23. immediately switch to his or her handgun.
  24. extractor
  25. concealment
  26. reload/left
  27. straight up
  28. unload/right
  29. using cover whenever possible.
  30. failure to eject
  31. a bore brush

    Bore Snake


    a cleaning rod


  32. scan the area for possible problems, including additional threats.
  33. critical to an officer winning a confrontation.
  34. the sake of change.
  35. patches

    a cloth


    Bore Snake

    gun solvent

    a cleaning rod

    a bore brush

  36. dictate that you reload with only one hand.
  37. cylinder should be closed and positioned so that the rounds fire in succession.
  38. Double feed
  39. invalidate the manufacturer's warranty or conflict with the manufacturer's recommendations.
  40. Concealment
  41. stacked feed
  42. squib load
  43. failure to fire
  44. ability to recognize hazardous areas and potential weapons.
  45. place each round together, leaving no space in between rounds.
  46. Leaning on your cover decreases your mobility.

    Muzzle flash may reveal your location, especially at night.

    Do not "crowd" your cover.

    Leaning on your cover increases your chance of being hit by direct fire or a ricochet or splattered by debris when projectiles impact your cover.

    Remember that ricochet or debris may disable your firearm.

    Exploit distance and angles.

    Remember to judge your position of cover from your adversary's angle or viewpoint and keep your firearm and body off the cover.
  47. gain a tactical advantage

    move if you need to reach a safer location.

    you may need to run, crawl, or "duck walk" to reach cover.

    you should select your next position before you move.
  48. solvent and lubricant specifically designed for firearms maintenance.
  49. squib load
  50. immediately switch to a handgun, if available.
  51. rags



    pipe cleaners

    Bore Snake

    cleaning pad

    patches (preferably cotton)

    nylon cleaning brush

    gun oil/lubricant (non-penetrating)

    bore brush
  52. not completely clean a larger firearm.
  53. consider the weapon bore when choosing patches.
  54. squib load
  55. 1
  56. in a safe direction.
  57. receiver
  58. more aware of and able to identify people, occurrences, and conditions that are out of place.
  59. an officer's observation skills.
  60. squib load
  61. immediately pull the trigger again
  62. Always be open to new ideas and tactics that may give you options to help you survive an armed confrontation.

    You must decide where to move for cover.

    You must know what suffices for cover.

    You must know when to move (for cover).

    You must be aware of the conditions of your weapon (loaded, rounds available, etc.)

    You must know if the location you choose (for cover) allows you to see the area where the threat originates.

    You must be aware of your surroundings.

    You must move quickly, safely, and without hesitation.
  63. Do not expose your body unnecessarily.

    Don't lock yourself into a bad position.

    Move quickly and decisively; use concealment if available.

    To properly use cover, keep your body and your firearm behind cover.

    When moving to cover, scan the area first.

    Always be aware of alternative options.

    Be aware of foot placement.

    Your weapon should be in a ready position, even while moving.
  64. Do not attempt to catch the magazine when it is released.

    When removing the magazine, hold the pistol in your shooting hand with the trigger finger outside the trigger guard.

    You should first engage the safety and then remove the magazine.

    Let the magazine fall to the ground after releasing it.
  65. malfunction
  66. double feed
  67. caliber specific.
  68. Check your weapon at regular intervals to ensure it is properly lubricated.

    Check the manufacturer's recommended lubrication points and amounts.

    Wipe excess lubrication off using a clean, dry cloth.

    A little lubricant goes a long way
  69. big enough to hide your body, and strong enough to stop bullets.
  70. the left of the top strap, if the cylinder rotates clockwise (so the cylinder can rotate).
  71. seat the magazine
  72. 1
  73. does not fit in a small weapon and may cause damage.
  74. squib load

    failure to fire

    failure to eject

    double feed

    failure to feed

    failure to extract
  75. Cover
  76. can
  77. double feed
  78. stovepipe
  79. cover when possible.
  80. wiping the inside of the magazine.
  81. Failure to extract
  82. failure to extract
  83. magazine port
  84. stacked feed
  85. Remove the magazine and secure it away from the weapon.

    Ensure that the bolt is locked to the rear.

    Safety check the weapon.

    Remove live ammunition from the cleaning area.

    Verify that the chamber or magazine contains no ammunition.
  86. concealment
  87. live round in front of the barrel in line with the firing pin.
  88. malfunction
  89. unload/left
  90. Cover
  91. frozen cylinder
  92. shotgun or rifle (or carbine)/kneeling
  93. Revolver
  94. stovepipe
  95. double feed
  96. reload/right